Google+
Pages Navigation Menu

Design, build, hack....zap and repeat!

Test Lead Snarl

Posted on Jan 15, 2014 | Comments Off on Test Lead Snarl

So I was putting together all the test equipment on the bench. Each piece of gear came with their own set of test leads. It wasn’t long before they began getting all snarled up. . .the BNC leads with the banana plug leads with the alligator clip leads with the adapters. Rather than wait and spend 20 bucks for a test lead holder, I dug through all my pegboard tool holders and come up with a good one. Since many of the leads were over 6 feet long, (2 to 3 meters for those outside the US) I needed to put the holders up a ways so they could hang straight. I decided to clamp a small piece of pegboard at ceiling height about 8 feet and use a few tool holders I had lying around. They’re cheap at...

Read More

New Tech Toys Pt.2

Posted on Jan 5, 2014 | Comments Off on New Tech Toys Pt.2

On to the workbench! The holidays brought an abundance of technology which I started to describe in Part 1: Overcome with technology.  Now I’m headed down to the workbench. Since I work on mobile and desktop radios, transceivers and associated equipment, many of which use 12 – 15VDC, I got a power supply dedicated to that voltage and amperage range. And since much of that equipment just plugs into the vehicle’s cigarette lighter, I chose an MFJ-4245MV which just happens to have a cigarette lighter jack built right in! While testing the transmit side of these radios, you somtimes need to measure the output power. So I got a dummy  load / wattmeter to measure the wattage while transmitting into a 50 ohm “antenna” without going out on the air. I chose the MFJ-267 since it could handle up to...

Read More